Answer / hemendra

yap, pure capacitor load n pure inductor load is an linear
load.
linear n un-linear are properties of electrical eqp. which
show the relation b/w V n I .
resistor , capacitor n inductor are linear bcoz when we
draw V-I relation, we get a continous graph means "OHM's
low" is follow so these are linear load.

but, when we show diode or other semiconductor eqp. these
are not follow the ohm's low so these are un-linear

Answer / rengan

capacitor load and inductor loads are non linear loads.
These loads works under ac supply.ac supply is alternating
quantity,not a constant.
so linear is impossible

HOW TO CALCULATE AMPs OF CURRENT TRANSFORMER IN HT Panel

0 Answers   MAB,

---

what is feeder bay?

0 Answers  

---

# 4 hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible my email id is sumit_lig189@yahoo.co.in

0 Answers   HPCL,

---

What is ignitor and why it is use in Hpmv lamp ?

2 Answers  

---

What are the voltage values for LT,HT,EHT and other voltages??

22 Answers   INEL, MNC,

---

---

why most of the substations are rated in multiples of 11?

4 Answers  

---

IN star -delta motors normally first operated in star mode {absulated given (r-y-b) phases after one miute change in delta mode in this case i am change phase sequience for example R -PHASE TO CHANGE Y-PHASE ;Y-PHASE TO CHANGE R-PHASE SO THIS TIME MOTOR WILL HAPPEN RUNNIG MODE EIGHTER(OR) STOP MODE(TRIP MODE)

6 Answers   MacLellan,

---

two parallel conductors are carrying the current in the same direction.which of the following statements is true? (a)there is arepelling force between the conductors (b)the force increases when the distance between the conductors is increased (c)there is an attaracting force between the conductors (d)the force increases when the distance between the conductors is decreased

1 Answers  

---

how mach PF mainten in DG

6 Answers   Siemens,

---

for any load, what happen if we use the cable rating above its normal rating

2 Answers  

---

hi i am aziz electrical associate engineer. i am faceing problem in acs800 vvvf drive.it is tripping wothout any alarm/fault.i cheaked all parameters and fault function of drive, all are correct as well as communication parameters.but still it is tripping (drive is tripping in running position not in starting)

1 Answers  

---

How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?

0 Answers  

---