Can anybody help me by attaching files , formats for quality checks of common building materials like cement , concrete , bricks , sand and aggregates? Regards,

45 Answers   CDS, L&T,

---

a butt weld is specified by

0 Answers  

---

how can change 10mm dia @275 c/c bar spacing to 12 mm

4 Answers   MEIL,

---

what is pouring and explain

0 Answers  

---

what is mix design?

2 Answers  

---

---

i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?

0 Answers   Public Service Commission,

---

CAN V USE CRUSH SAND FOR CLAY BRICK MASONARY

0 Answers  

---

How to check slab shuttering level.? Or check list for slab ?

0 Answers  

---

1) what do you mean by rolling margin of steel ? 2)pls. tell the cut length formula of stirrups as per IS codes(take out cut length for a beam of 600*300mm with 40mm cover all sides)? 3)what is the multiplying factor of painting for sand faced plaster? 4)if your footing is of size1.9*1.6m . what quantity of length and width you will excavate means what extra margins you will allow as per IS codes in billing?

1 Answers  

---

What is the standard rate of installing ties for column(60cmx60cm) and beams(50x850)(weight)

0 Answers  

---

calculate for 1 m3 cement, sand, coarse agree gate ,kg?

4 Answers  

---

what is the difference between site engineer & site incharge

5 Answers   Infosys,

---