1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.

0 Answers  

---

what is stator inter turn fault?

1 Answers  

---

What are all the conditions to protect generator & turbine in thermal power plant?

1 Answers   Power Grid,

---

What is a single phase autotransformer?

0 Answers  

---

How to decrease or increase the range of voltmeter? can an ammeter be used to measure voltage? can a wattmeter used as voltmeter and ammeter?

3 Answers  

---

why our power production in multiple of 11, in strictlly asking why our o/p voltage of alternators is 11kv only and whynot graterthan 15 and016KV?

4 Answers  

---

what is meant by lagging & leading current

1 Answers   TATA,

---

1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?

0 Answers  

---

In single core cable, Why non-magnetic material is used??

1 Answers  

---

Why machines are avoided to work is saturation region of B- H curve?

3 Answers  

---

how does the switching of capacitors in a capacitor bank take place when we use them at the load side to reduce the power factor?

2 Answers  

---

What will happen if the 50HZ Transformer is connected with 60HZ power Supply

2 Answers  

---