Answer / nikhil choudhary

The easiest way to set up a parallel system is to use generators that are exactly alike, or at least have the same output rating. Another flexible approach to backing up your power requirements is to have two or more generators of variable output. In either scenario, these can be connected in parallel with paralleling switchgear to achieve maximum output during peak requirement or the desired minimal output during other times. For parallel operation you have to synchronize all generator units (Voltage, frequency, phase angle).

if our motor load is 150 amp v- kv and we want to install capacitor bank then what is the exact value of that capacitor bank that we should install?and how we calculate that

0 Answers  

---

what is load balancing. what maximum load diffence is allowed between phases.

1 Answers  

---

why celing fan is running in anti clock wise and table fan is running in clock wised?

2 Answers   Ambuja, Infosys, MAHINDRA,

---

how to select the isolation tranformer for siemens 802dsl cnotroller

0 Answers   Siemens,

---

why we are using the 2 slope in differential relay?but in busbar differential we are using only one slope. what is the reason.

1 Answers  

---

---

what is the difference between high impedance and low impedance circuit?

2 Answers  

---

what is the effect when the shunt field winding is opened in dc shunt motor (i) at the time of starting ? (ii) in running condition ?

4 Answers  

---

Why do u join toreent power ?

1 Answers  

---

How to synchoronize the generator (with gcb,GT) to grid????? ????? from Grid iam getting power (rated 400kv/20kv) through GT and its goes to UAT.,,ST.,, now my generator(rated 20kv ) ready.,, now iam closing my GCB.,, in GT iam suddenly giving 20kv on that Gt.,, what will happend

0 Answers  

---

how gen. load increase or decrease ? what happen with gen on that time

2 Answers  

---

a 3 phase slip ring induction motor is wound for 4 poles on stator and 6 poles on rotor; when 3 phase balanced voltage source at 50 hz is applied to motor it will run at a)1500rpm b)1000rpm c)750 rpm d)zero rpm

13 Answers   Essar, PSPCL, PSTCL,

---

What is the resonant peak?

0 Answers  

---