Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plants instrumentation field , which one field is give long life & which one field is best ,I confused a lot And also I'm studying AMIE, can I choose which field from Section B examination?
hi all plz tell me difrence between analog or digital load cell.
WHY WE WILL USE 0-24VdC IN ELECTRONIC CIRCUITS AND INSTRUMENTATION TRANSMITTERS?
3 Answers Aban Power, Jindal, JSW, Sugar Factory,
why bevelling is done in an orifice ?
Can we use thermocouple in generator of power station replace RTD(pt 100)? if we don't have any place for use RTD.
Is wet leg type system nessesary to measure water level of steam DRUM? How the transmitter is calibrated to measure this level?
in DCS or PLC we can not put all ai or di,there is calculation through which we can accomodate certain no of digital and analog signal.I need to know that calculation
what is the thermocuple compensation circuit
why magnetic flow meter is not used in thermel power plant operation
what is lead lag compensator and for wat v using that???
What is the GK Value in Flowmeter?
steam drum level transmitter calibration procedure? with example?
You are looking at the RS-485-side of an RS-232/RS-485 converter and the power supply voltage for the converter is +5V. Under idle conditions (no transmission), and assuming you have enabled the RS-485 output: what would you expect at: (a) Output A measured against output B (b) Output A measured against ground (c) Output B measured against ground