I am a instrument technician. recently i attend interview and face one of questi

I am a instrument technician. recently i attend interview and face one of question for DP transmitter ,the client asking about the calibration of DP transmitter ,am answer the calibration procedure, they will ask one more question. why open LP side in atmosphere? i did not answer that question. so please help me and explain the particular question. Dear firends waiting for your valuable replay

Question Posted / rohiths990

3 Answers
5745 Views
Qatar Petroleums, Samsung, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

I am a instrument technician. recently i attend interview and face one of question for DP transmitte..

Answer / ashrafsmiles

The pressure in the open tank is Atmospheric pressure only. so no need to compensate the pressure at LP side. Just leave it (LP Side)to atmosphere.

Is This Answer Correct ?

22 Yes

2 No

I am a instrument technician. recently i attend interview and face one of question for DP transmitte..

Answer / ahmed

Calibration coefficient we titration differential pressure device through the injection amount of pressure in the high side and at the same time the low side open to atmospheric pressure, because pressure air fixed and unchanging and the device works on the difference between Aldgate if the equation realized there atmospheric pressure fixed and your controlled pressure from here the differential pressure is measured

Is This Answer Correct ?

1 Yes

0 No

I am a instrument technician. recently i attend interview and face one of question for DP transmitte..

Answer / ilaravii

in calibration lab we have atmospheric pressure as Low Pressure for DP transmitter, since we keep the LP open .

Is This Answer Correct ?

0 Yes

2 No

Post New Answer

More Instrumentation Interview Questions

what is loop?

4 Answers

what is virtual instrumentation

0 Answers

How to calibrate the magnetic flow meter and how to correct the flow if it is showing more flow.

5 Answers Bohra Industries Limited, TCL,

WHAT REASEAN USE TRANSMETER TWO WIRE & FOUR WIRE

5 Answers Kentz,

what are the difference between conventional and smart transmitter.

1 Answers

Name some of the common protocol use in automation.

3 Answers Empower,

We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.

0 Answers OPaL,

please send me hpcl placement papers

13 Answers HPCL, L&T,

what is absolute pressure and where use in process?

3 Answers

what is difference between OP AMP and differential amplifier?

5 Answers TCS,

For an Instrumentation Engineer, is there any effect on Instruments of safety zones like zone0, zone1, zone2. As an instrumentation Engineer, what we have to consider or remember while working in these areas.( zones 0,1,2).

1 Answers

what will happen if transmitter wire get shoted?

2 Answers Sabic,

For more Instrumentation Interview Questions Click Here