Answer / syed kashif

IF Resistance is constant.Current is directly proportional to Voltage.
V=Voltage=V
I=Current=A
R=Resistance=R
  
       V = IR

Answer / rajkumar

 At the constant temperature, the flow of current through the conductor is directly proportional to the voltage across between the two end of conductor..  

Answer / nupurpatel

in physical condition,resistor is proportional to the voltage and inversely proportional to the current.

         R=V/I

Answer / karthikeyan

voltage is proportional to current and inversly proportional to resistor

Answer / vibhor

If physical conditions of any conductor are held constant then the ratio of voltage across it and current through it is costant

Answer / manwendra tiwari

If any counductors materials three phyicescal propaties as Valume,Tempreture and preccurs have consent, in which conductors the flowing currunt is profsional to voltage V€I and V=IR where R is resitance or ohms consetent

Answer / santhosh kumar

The current is directly propotional to voltage & inversly propotional to resistance kept the tempreture constant

what will happen if the prime mover on the field excitation of the on-coming generator fails?Explain.

0 Answers   Ahsanullah University of Science and Technology,

what is function of reactor coil in Power factor correction panel

1 Answers  

what is the diffrance with elcb,rccb,mcb

2 Answers   Thomson,

2.5mva transformer is installed in our company with oltc but it is not working in auto mode ,it is operative in manual mode control wiring is done how can i rectify it?

5 Answers   Imdaad,

about transformer oil material & Test name for the measurement of its dielectric strength & wht will u do if its dielectric strength goes low ?

2 Answers   NTPC,

What happens if we give the supply to the rotor of induction motor and make its terminal shorted?

2 Answers  

AT THE TIME OF INSTALLING THE POWER PLANT POWER IS TAKEN FROM NEARBY GRID AND GIVING THE SUPPLY TO THE GENERATOR WHICH ACTS AS MOTOR. WHAT IS THE NEED OF RUNNING THE GENERATOR AS MOTOR?

6 Answers  

What descriptive information does the NEC require to be marked on all conductors?

0 Answers  

WHAT IS THE USE OF PIG TAIL IN WINDOW TYPE CT ?

3 Answers  

if two transformers are parallel & both have fault short ckt. impedance of 50KA in each case will it increase or decrease show example?

1 Answers  

What is the cause for a blown fuse in one phase of primery side(HV) of a three phase transformer( 4169v-460v) in the time of closing its supply breaker. There is no load on the secondery side of the transformer in this moment.

3 Answers   Novachem,

what the different types of cables used for 11kv and 33kv over head work and what is the size of cable in sqmm.

2 Answers   Ordnance Factories Board,