Answer / rajendra.s

It depend on which metal you are using copper/aluminum.
& it also depends on density.
to calculate busbars multipy cross sections.
For AL if density is 0.7/1A
Eg.for 100A incomer density .7 busbar is 20x10MM=140A.
with 1A density 10x10mm=100A
For CU standard density is 1.5/1.8A

From Rajendra Sawant
Miraj

when voltage gets down the current of motor increases. but according to Ohm's law voltage is directly proportional to current. plz explain

4 Answers   Maruti Suzuki, TATA,

---

my motor rating is 800HP, 128Amps, 3.3kV. What is capaitor bank i can use for PF improvement to 0.990?

3 Answers  

---

why the starting torque is high in dc series motor..

3 Answers   GM General Motors,

---

What precautions we have to take while handling electrical equipments?

1 Answers   Bharti,

---

What is the difference between AVR and Servo Stabliser

3 Answers   Wipro,

---

Dear all,recently in our plant we installed a conveyor for this the motor ratings are 5 hp and Amps 7.39.Due to on urgent starting of conveyor we fix the DOL starter with range of 9-15 amps.give me suggestion regarding on this issue

1 Answers  

---

Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet

0 Answers   Bindal Papers,

---

Hi ,what the accurate method to set correct(In) over load to protect the 3~ motor

4 Answers  

---

How to select batteries required for ups and the inverter if we Known load? And how AH is selected of battery?

0 Answers   Vodafone,

---

what is the difference between current rating and breaking current of an MCCB? and for a known load how to calculate the current rating of a MCCB?

1 Answers   HPL,

---

what is the voltages using in movie theaters??? why ??why not other??

0 Answers   Lanco,

---

How to calculate CT ratio for 11KV 1500KVA Transformer 500KVA MD and 1400KVA connected load ? Note:- As per MSEB(Maharastra state electricity Board)

1 Answers  

---