Dry type transformers
No Answer is Posted For this Question
Be the First to Post Answer
Do these factors (settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot)) are the part of first order, second order, higher order, linear, non-linear, open-loop, closed-loop, homogeneous & non-homogeneous systems ?
how many mega ohms insullation of the cable can't be use when testing with megger tester for Low voltage cable 240V use?
A 6-pole, 50 Hz, 3-phase synchronous motor and on 8-pole, 50 Hz, 3-phase slip-ring induction motor are mechanically coupled and operate on the same 3-phase, 50 Hz supply. If they are left open-circuited, then the frequency of the voltage produced across any two slip rings would be
How much is the starting current for HPMV lamps. How many lamps can u wire in a circuit
which tap of the transormer you will use in critical condition(worst)?
For what purpose an AVR in generator sensing generator output voltage?and how the sensing is done by AVR?
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
Why grounding is generally done in supply end?
HOW isolation transformer works.
Please elaborate th´evenin’s theorem?
what the good value of earth resistance test