what is vA rating and class of a ct.
No Answer is Posted For this Question
Be the First to Post Answer
if we convert Ampers into kva,which one formula use by us,pls tell me?
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
For polarity test on a 11/3.3kV 2.5MVA delta-star Unit Auxiliary transformer,415V 3-phase supply was applied at the HV. Connection between Aa was made with a 2.5mm cable. As soon as power was switched on the cable caught fire and burnt. This test was then abandoned. It is noteworthy to say that a similar cable was also used in a similar transformer for the same. The cable did not burn and test was successfully completed with good result. What is wrong? Please, help me out.
what happens if dc supply is given and the remedies for it.
Is it necessary to carry out sheath test after cable jointing? If the value is zero of such instance , is it ok to energize the cable?
In dc motor starter there is less voltage required for holding contactor that's may why it is called no volt coil. but in ac starter why holding contactor is called no volt coil.
How much current can carry the 1 sq inch super enamelled copper wire?
how to calculate cooling requirement of datacentre from electrical load?
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
how to check the 3ph capacitor is good or not.
14 Answers MacLellan, Yash Technologies,
how to find the ballast lost from the actual wattage? for example i am going to buy decorative type 2x36watts fluorescent light fitting for this lamp how to find the ballast lost? is there any formula?
why transmission is only 3 phase and not 2 or 4 or poly phases