Answer / sunil kumar kr

I feel the question is an imaginary one as normally no such requirement arises. However the answer is yes. Once these generators are synchronised it will share the load based on the droop settings.

Answer / haresh

yes

WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.

0 Answers  

---

We have AC-transformer 110/13.8kv,40MVA.If DC-Voltage=110kv is applied in its primary what will happen?

6 Answers  

---

what perpose of use CT ratio in gt,st,uat

1 Answers  

---

the input mechanical power of a single alternator is increased,its RPM increased but in case of an alternator synchronised with grid its RPM does not increased with increase of input mechanical power. why?

3 Answers   Bhel,

---

I am final year b.tech student..i applied for gate but i am not interested any of my engineering subjects. i am interested in management wise.. is my option correct after b.tech..

1 Answers  

---

---

What is mean by ideal infinite bus? Why it is required to consider in fault short circuit calculations?

1 Answers  

---

what happen when increase or decrease size of lamp,light.glass.

0 Answers  

---

what is meant by HT&LT?

5 Answers  

---

Why synchronous motor runs at a fixed speed? what is the name of that fixed speed?

4 Answers  

---

HOW TO CALCULATE THE VT SIZING?

0 Answers   L&T,

---

what is the difference between bus-coupler and bus-riser

2 Answers  

---

1 no. 22 kV feeder is taken from state electricity board. 350 MVA is the S.C. MVA. now i am feeding this feeder to HT Panel having 2 outgoings which further supply to 2 Transformers. Can you please suggest me the type & rating of cables are 3 of these cables same? or they are different? please help...............

2 Answers   TCE,

---