Why starters are using the machines???
Answers were Sorted based on User's Feedback
Answer / deepak24
starter are used because of the following reason-
1. to start and stop motor
2. for protection (short circuit protection, open circuit protection, thermal protection, over voltage etc.)
3. to improve starting torque of motor
4. to limit the starting torque
Is This Answer Correct ? | 13 Yes | 1 No |
Answer / nishwa
stat and stop operation,
to limit the starting current(star delta starter),
over load current and fault current and shot circuits current that current sense by relay,
variable speed operation
Is This Answer Correct ? | 9 Yes | 1 No |
Answer / sainianil
starter is mainly used for the protection of machine and we with the help of starter we can able to isolate the machine from the main power supply in case of fault ,
the following items used in starter are:-
1 isolator: to cut the main supply to the machine without effecting the system
2 fuse: for shortcircuit protection
3relay for the overcurrent
4 contactor controlled by the control ckt
now a days it is replaced by the MCB because of its longlife..{FOR SHORT CKT AND OVERCURRENT}
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / nupurpatel
To start and stop the motor,
To limit the starting current,
To limit the high starting torque.
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / pitchi reddy
To limit the starting current and to protect machine for high currents
Is This Answer Correct ? | 0 Yes | 3 No |
Q. calculate the value of the resistor to be connected in series with a 100W; 230V lamp so that the wattage of the lamp is reduced to 35W
my self i am raghu working as tech.. in my college the maximum demand is 211 kva presently we are using 12kva capacitors the target power factor is .95 so what capacity of capacitor banks should i install
The basis on which voltage selection of motor is done i.e. either HT or LT.
What is the purpose of Rotor earth fault relay and How to test the Rotor earth fault relay in generators and What is the procedure?.
HOW MUCH MAXIMUM CURRENT TAKEN BY NEAUTRAL IN 125 KVA DG SET
Define pole pitch?
Is it alright to connect more than one RCCB of same rating in series for a three phase equipment?
What are the roles and responsibilities of electrical engineer in cement plant
Which of the following loss varies with the load A hystresis loss B eddy current loss C copper loss D core loss
why the vector group of excitation transformer is YD5(150 deg)how is this factor decided.
How LT megger works ?
explain why reduced voltage starters are required for large tree phase inudction motor