Close loop and open loop.
- 3 Answers
- 5792 Views
- CCIE, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / sushil jambhulkar
IN OPEN LOOP INPUT & OUTPUT ARE INDEPENDENT.
IN CLOSE LOOP INPUT IS DEPEND UPON OUTPUT.
| Is This Answer Correct ? | 7 Yes | 0 No |
Answer / veera
*open loop for monitoring purpose, there is no control action taken place.
*closed loop for both monitoring and control purpose.
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / guest
close loop consist of final control element..example:contol
valve
open loop does not consist of final control element..
example: motor
| Is This Answer Correct ? | 1 Yes | 5 No |
What are the advantages and benefits of using PLCs to automate a section of a plant?
Dear Sir/Madam, I am attending an interview for ETs in BHEL. I have cleared my written test under Electronics (Instrumentation). This is the first time I am appearing for an interview. Can any one who has attended the interview earlier give me a clue to face the interview. With regards Sindhu
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
what is the importance of CV in the control valves? how it is calculated?
what is the difference between PLC & DCS
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
where do you give the 4-20 ma i/p in a MIL control valve?
what is the diffrence between mmwc and kg/cm2 for pressure measurment when we are using mmwc and when kg/cm2 and why????? ?? what is the reason
19 Answers Ecoboard, Jindal, Sepco,
what is written on orifice plate?
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
What is difference b/w absolute & gauge pressure? EXPLAIN
-
Civil Engineering (5085) - Mechanical Engineering (4451)
- Electrical Engineering (16632)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
