Answer / rithesh

in horizontal or vertical pipe while installing we have to
take care about that it should be right angle to
pipe .there should be clearence of angle from sensor part
as specified by vender recomdetion.

Answer / vikash (ineos abs)

Also,take care that it should install in such a way
thatit's glass bulb should always remain wet.
it is very important.
Also exact infrnt of the the sensor at opposit side you can
provide spary assemly to clean the bulb regularly without
removing it.

whatis diference between zero pressure and obsolute pressure

1 Answers   ABB,

---

If a normal magnetic type flow transmitter that can measure flow, temperature and show this parameters on field, is it possible by any means to get this (flow and temperature) parameters info. On dcs? And if yes then with HART, FO communication or any other communication system?

1 Answers   Process Control Technologies,

---

what is mean by loop checking?

8 Answers  

---

What is cascade control in process instrumentation?

4 Answers   Engineers India, ITC Infotech,

---

Which type of pressure can be measured by these elements?

0 Answers  

---

Why we using 250ohm resistance during lab calibration and why not using in field in one plz define deeply???

1 Answers   Cisco,

---

what is intrinscily safe system and where we use?

0 Answers   DEWA,

---

What is difference between radial vibration and axial vibration explain in detail .

0 Answers   Emerson,

---

Define all the process Variable and state their unit of measurement. ?

0 Answers  

---

wht is mean by dpt(differential pressure transmitter)

1 Answers  

---

what is a boiler tube leakage detector? ... what is the working principle ?

1 Answers  

---

Can we calibrate an actuator?

5 Answers   Siemens,

---