Is it benefitial to supply 210v ac to lighting fixtures
instead of 240v ac?
Answers were Sorted based on User's Feedback
Answer / shyamal h. mandirwala
Yes it is.p=VI as V decreases ,P decreases.However some
ballasts might not pick up if voltage is very less.
Is This Answer Correct ? | 0 Yes | 0 No |
Why stand-by earth fault relay and restricted earth fault relays are connected between neutral and ground in transformer?
what is the condition for YnD11
Can you tell me more about pu systems (per unit systems )calculation in large power systems? how to get the base for voltage and power in generator, transformator and transmission lines?
1. When do you use a VFD motor? 2. If the ceiling fan is on slow speed, does it consume less electricity? 3. If we want the fan to consume less electricity at low speed, what do we have to do? 4. What does “battery of 180 AMP HOUR” mean to you? 5. What does “battery of 180 AMP HOUR” mean to you? 6. If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
6 Answers Asian Power, Bhel, Focus, Focus Energy, L&T,
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
( Re: WHAT SHOULD BE THE RATING OF MCCB FOR 415V,3Ph,50KVAR CAPACITOR BANK Answer # 1 The capacitor current would be kvar x 1000 / (415 x sqrt3). This would be 70a approx. The MCCB selected should have *atleast 1.4 times this current i.e. 1.4 x 70= 98. So you should choose at least 100 A mccb.) regarding to this answer,i would like to know why the current have to times 1.4 to get the right amphere for the mccb.hows the formula to get the 1.4??tq
how many bulb of 60watt at 300volt is used to maintain 0.25 amp.with valid reason?
What is the operating principle of turbo-generator.
Hi.. I am a BE GRaduate in E&E. I have 8.5 Experience in Tendering & Estimation field. I have done SAP SD course few years back. But due to some reason i failed to get job in that field and continued my own field. Now I am thinking of changing into SAP seriously. How should i go ahead???
in Contactor opearation Why there is a difference in the values of the operate and release voltage in case AC supply
What is Harmonics & what are its efect & which harmonic is dangerous
what are the problems are there if power factor is leading