what is the function of short circuit maintenance ct and
droop ct.
These are both used on a DG.
The short circuit maintenance CT is used to keep the output
voltage and current high enough to clear a fault by
tripping an overcurrent device (circuit breaker).
The droop CT is used to cause the voltage to decrease as
the kvar load rises. This is used to help DG's share the
kvar load.
Is This Answer Correct ? | 2 Yes | 1 No |
what is mean by power factor
Dear all, kindly give me the details of leectrical design engineer course details/institute in hyderabad /any where in india.
What should be the height of basement according to NBCC code?
IN TWO WATTMETER METHOD WE GOT W1,W2,WE KNOW V.HOW TO FIND Q????????????
IN OLTC we observed "OUT OF STEP" Alarm, we have two different transformer, when both are in parallel this type of alarm observed. what's the meaning of this alarm and why it occurs???
what does mean for "mah" for mobile batteries like 1500mah,1300mah??
CAN ANYBODY PL TELL ME WAT FACTORS CAN CAUSE UNDERVOLTAGE ON A BUS??? PL LIST ALL THE REASONS WITH SOME EXPLAINATION
725KW Three DG set Synchronised but DG no-1 power showing 750KW DG n0-2 power showing 500KW DG no-03 showing 500KW. DG is Shynchronised but why this different power showing?
What is the universal motor?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give
how can calculation ate Amps for cabel. Ex-for 1sqmm wire hou many amps we can draw