How we calculate the size of H.T cable for any transformer &
rating of busbar for any L.T. panel?
Answers were Sorted based on User's Feedback
Answer / sakthipriya m
Rating of busbar L.T.Panel
Current rating - Depends on the incomer of L.T.Panel and kva
rating of the transformer.
e.g.
If the incomer of L.T.Panel is 1000 A then rating of aluminium
bas bar will be 100X10X1R
Is This Answer Correct ? | 4 Yes | 1 No |
Answer / cameo_0102
to know the desired
rating of busbar
just multiply its
width & height(not
length),the result
will show the max
load,that it can
bear.
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / ritumoni
rating of LT bus bar depands on the ht cable & load current
Is This Answer Correct ? | 1 Yes | 1 No |
what are upstream faults and downstream faults in power system
why r we using shell transformer for low voltage
we have one 75kw motor 380 volt 3ph amp134 please advise which size of cable required
how to calculate units consumption for a 12 hp motor /hr.
What is the minimum value of hfe for the oscillations in transistorized rc phase shift oscillator?
What is Cement
11 Answers ACC, L&T, Reliance Cement,
What is the gross weight to copper ratio in slip ring induction motor of 4000 HP,6.6 kv, 372amp, 992 rpm GE motor.
How many earthing pits required for diesel generator set ? Why ?
where we use 1 phase & 3 phase supply ?what is major advantage using 3 phase over than single phase ?
how generator avr give to the input?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
What is inrush current?