Answer / aamod tripathi.

Commissioning a distribution transformer knowing all its
rating, Transformation ratio, Vector group, Phase sequence
is a skilled Job. You will need the information of complete
system like where the distribution transformer you are
talking about comes.

Information needed will be,

1. Single Line Diagram of the complete circuit (So as to
clearly understand the vector group/ rating of the
transformer to be installed, if there are many distribution
transformers to be installed in a locality).
2. Transformer foundation drawings and the drawings of
Bolts where the transformer will be bolted.
3. Whether to be installed on ground/ On pole
4. Whether oilfilled/ Drytype.
5. If oil filled provision of soakpit and clearances from
firewall.
6. If conservator tank and radiators are there the clearances
7. Provision for grounding.
8. All drawings of transformers from all angles.

How much pole motor can be desion for 415 volt ,50 hz.Power supply. in pratical condition . Prakash veer singh

5 Answers  

---

Why we use Electrical energy rather than any other type of energy, mostly? Explain behavior of open secondary CT and short circuited secondary PT in energized condition?

0 Answers  

---

how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.

1 Answers   Bhel, Indorama, Power Grid,

---

How can i learn to programme every VFD. Or is there any typical study to understand VFD programming.

1 Answers   Volkswagen,

---

what is the function of choke and starter in a tube light?

2 Answers  

---

i have a Connected Load of 280KW and Maximum Demand of 224KW to one of SMDB under design with me. which criteria should i consider to design panel and main cables connected Load or Maximum Demand 1)Breaker rating 2)Panel Busbar rating 2)Incommer cable sizing (ignore Voltage drop)

1 Answers  

---

how to calculate the capacitor rating for improving power factor

10 Answers   L&T, Property Solutions, Synergy, TAFE,

---

Why size of HT cable is less then LT cable inspite of the fact that voltage is higher in HT cable?

2 Answers   L&T,

---

Why motor is not calculated in kva, whereas transormers are calculated in kva

2 Answers  

---

What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??

0 Answers   Siemens,

---

how can we calculate the cooper armed cable size if the protection load of main fuse is 80 ampere.

1 Answers  

---

What is the basic diffrence between Electronics & Electrical engineering

13 Answers  

---