how the high voltages are produced?and what it causes?

Question Posted / m.kishore kumar

4 Answers
5183 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

how the high voltages are produced?and what it causes?..

Answer / priyanka

high vtgs are produced by high vtg surges,a sudden
increase of voltage damages the equipment throughout t/m
line so surge absorbers have to be used to protect the
equipment as it is very costly.

Is This Answer Correct ?

2 Yes

1 No

how the high voltages are produced?and what it causes?..

Answer / yaswanth

high voltages are can also produced either electerically or
electronically.it is used to test the equipment's critical
voltage.ex.Insulation measuring, t/f oil testing.

Is This Answer Correct ?

0 Yes

0 No

how the high voltages are produced?and what it causes?..

Answer / chandrasekar

impulse generator can be used produce very high voltage for
short duration. And this high voltage is produced to test
electrical equipments like transformer , lightning arrrestor etc

Is This Answer Correct ?

0 Yes

0 No

how the high voltages are produced?and what it causes?..

Answer / alok

High voltages are
produced as a result
of various unwanted
factors like harmonics,
and these have to be
rectified from the
system, either they
may cause temporary
or parmanent damages.

Is This Answer Correct ?

1 Yes

2 No

Post New Answer

More Electrical Engineering Interview Questions

how many winding in the single phase transformer?

3 Answers

what is the mean of"turbo" in turbo alternator???

1 Answers CCCL,

what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY

0 Answers L&T,

Can we pass 11kv power in 1.1kV voltage grade cable.If not why?.

3 Answers

What is an alternator impedance value?

0 Answers Orchid,

what is meant by oil filled power & distrubution transformer ? if anybody know the link of detail about above transformers means plz send it i have interview on this week ? plz help me

3 Answers

why the carbon brushes are used heat created rotating parts in eiectricity

1 Answers

Why the ratation of fan is anticlockwise all over the world?

2 Answers GNFC,

HOw can we calculate power factor at HT side.

6 Answers

how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.

0 Answers OPS,

how to find out capacitor range?

2 Answers

why voltage drop will occurs in 3 phase line?

12 Answers ABB, Servo,

For more Electrical Engineering Interview Questions Click Here