what are the C&D CHECK OF DG set

Question Posted / shabi haider

1 Answers
5817 Views
HCL, I also Faced
E-Mail Answers

what are the C&D CHECK OF DG set..

Normalley as per cummins generator commpaney recomanded

injecter checking, and valve clearence,flywheel bold

retorqch ,crankshaft end play, fan belt, fan hub bearings,

idler pulley bearings cheaking and grease refilling,

includind B' cheak [oil and filtters changing] theese are

C & D cheak

Is This Answer Correct ?

1 Yes

2 No

Post New Answer

More Electrical Engineering Interview Questions

how can we select the type of wire.what factors we have to look on it , do we have some formula to calculate it. please guide me on it

0 Answers

What is the difference between tie bus and bus coupler?

1 Answers

we can stepdown the voltage from 230/12v ,and we use the voltage for various electronics components why can't we step up the voltage from 12/230v if we can shall we use the voltage for domestic single phase supply

5 Answers Areva,

when voltage increases then current also increases then what is the need of over voltage relay and over current relay? can we measure over voltage and over current by measuring current only?

1 Answers

Actually why the transformers are rated in KVA.?

4 Answers BSL, Engineering,

i need bhel question papers.

5 Answers Bhel,

HOW TO CALCULATE EHV CABLE SIZING?

2 Answers L&T,

what is charger supervision and control supervision?

0 Answers

How to calculate voltage drop loss in HT 11000 Volts XLPE Aluminium conductor cable. Any specific formula or Thumb rule

2 Answers

i have 400/230v transformer and didnt done the neutral eatrhing. i connected one lamp to one phase and neutral to the earth. but the lamp is not glowing. again i connected neutral to earth and repeated the same. then the lamp is glowing. in the first condition i tested with a line tester also, at that time the tesrer is glowing what is happening i dont know can any one help me?

1 Answers

how will you determine the short circuit capacity of a network

3 Answers Dalkia,

please let me know , we have installed two separate motor for fire fighting system 1) 60 hp and 2) 15 hp the load is 74 AMPS and 20 AMPS then tell me the main power cable in Aluminum will be what thickness , the length is 225 mt from the main utility to fire pump house

1 Answers

For more Electrical Engineering Interview Questions Click Here