Are Coils of Electromagnetic flowmeter in direct contact with fluid material

Are Coils of Electromagnetic flowmeter in direct contact
with fluid material

Question Posted / jaancsinha

4 Answers
8392 Views
TATA, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Are Coils of Electromagnetic flowmeter in direct contact with fluid material..

No. as we know elctromagnetic flowmeter works on principle
of Faraday's Law of electromagnetic induction for flow
measurment.but fluid must be electrically conductive.

Is This Answer Correct ?

10 Yes

0 No

Are Coils of Electromagnetic flowmeter in direct contact with fluid material..

Answer / chandra

Electrodes of flowsensors generates pulses that are
resulting from conductive fluids and measured in terms of
flow as per faraday law

Is This Answer Correct ?

2 Yes

1 No

Are Coils of Electromagnetic flowmeter in direct contact with fluid material..

Answer / www.islamqa.com

the answer is no.

actually magnetic flowmeter is based on Faraday's law, the magnet is prefered to be electrically produced and the polarity is reversed with timing to avoid flowing material polarization.

the electrodes/wires are in direct contact with the fluid material, as we consider the passing material is a series of consecutive fluid conductors.

Regards,

Ahmed Sabry
Control and Instrumentation Engineer
GPC - General Petroleum Company
ahmedsabry.online@gmail.com
CELL.: 00 2 0121367310

Is This Answer Correct ?

1 Yes

0 No

Are Coils of Electromagnetic flowmeter in direct contact with fluid material..

Answer / jigar anadkat

Now a days, both types of flow-meters are available. In earlier days, the electrodes were in direct contact with the fluid being measured. Then after retrofit design has been developed in which electrode assembly can be replaced and it is isolated from the process fluid.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

in transmiters(rose mount) how to check output 4-20ma ? and input 24v? i need exact explanation?

2 Answers Adhunik,

What is purpose of shield wire?

1 Answers IFFCO,

suppose there is gas flow meter I want to know weather meter calibration is done at high pressure or low pressure? pls justify.

2 Answers Siemens,

What is BMS (Building Managment System)& is AHU / HVAC are in BMS.

12 Answers Alghanim,

Identification of control valve parts.

0 Answers CCIE, Oil and Gas Jobs,

How much should be the values and/or percentages of these given below factors for a good controller ? Steady state error Delay Rise Time Overshoot Peak Time Settling Time Damping Oscillations & vibrations thanks

1 Answers

What is the difference between a PLC (Programmable logic controller) and DCS (distributed control system)?

7 Answers

what is the function of 3 way manifold valve in a closed loop system?

1 Answers Emerson,

What will the new flow factor if D/P Transmitter is RE-RANGED from 25" WC to 50" WC

3 Answers ADMA OPCO,

CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?

0 Answers GSC,

How to calibrate electronic type level switch low?

1 Answers

why we use only 4-20 ma signal as AI and not 0-20 ma?

2 Answers Honeywell, Oil and Gas Jobs,

For more Instrumentation Interview Questions Click Here