Answer / k.prakashchandra

The pf is the reason ,as ac power output of alternator is
=Kvaxpf whereas the pf of dc motor is always unity and Kva
=Kw

Answer / hemraj

generally,the rating of any machine is decide by losses of
that machine depends on what factor.losses in gen. are
depend only on generated voltage & gen. current. so rating
of gen. is in kva.
in dc motor losses are depend on voltage & current and this
losses are also depend on application of dc motor i.e power
factor of load which is connected to that dc motor. so
rating of dc motor is in kw.

Answer / sukant

generally in case of generator n motor d rating shows d output power....in generator we get electrical energy as output having both active n reactive power.so its better 2 show in kva rating.....bt in case of motor we get mechanical power as output.....so it is represented as kw not kva............am i right???????????

Answer / sukesh

as we know that rating of any machine is decided by its temp
rise.temp rise due to the presence of losses in the t/f.
2 losses are there .one is iron loss and other one copper loss.
\iron loss depends on voltage.(v.i).
cu-loss depends on current.(i2.r).
so rating of t/f as well as generator both is in kva.
and for dc motor see the reply of HEMRAJ.

Answer / sathishkumar

generator is a source and the losses only due to current
(iron loss) and voltage (copper loss) so there is no power
factor involved so capacity is P=V*I in terms of KVA.
where as in motor there is either inductive load(laaging
P.F)or capacitive load(leading P.F)involved so capacity is
P=V*I*power factor i.e interms of KW.

Answer / raman singh panwar

in gen. losses depend on voltage and current thus its rating is given in KVA.
but in dc motor the losses depend on voltage,current and power factor thus its rating is given in KW.

Answer / man

the load of generator is always a mechanical load which do
not bring about any appreciable change in the power
factor.hence its rating is in KVA.where as in motor the load
is electrical load and it brings about change in power factor
so its rating is in KW.

why current is constant on d.c?

0 Answers  

What is the type of electrical motor used in mining industries?

2 Answers  

how would you come to know if a transformer is double wound or auto? note that there is no tag. you are given only a multimeter.

5 Answers  

what is the purpose of ignitor in lighting fixer

1 Answers  

why ligthing is not available in switch yards?

1 Answers  

Why rotating machines are not allowed to run near critical speed region?

2 Answers  

Determine the minimum cable size for a 28A single phase final sub circuit originating from the distribution board supplied by three phase submain. The route length of the final sub circuit is 54 m. Assume 1% voltage drop in the consumer's mains. Submain specification: Cable: 50mm2 4 core V75 copper; Route length 42m; Maximum demand 135A per phase

1 Answers  

Give the topology of current amplifier with current shunt feedback?

0 Answers  

how invertor convert the dc into ac give brif detail

0 Answers  

What is ESP how its work &what is corona ? con insulater&drive insulater where it is used ? Any body says that pls

3 Answers   Travancore Titanium Products Ltd TTPL,

What is the difference between generator and turbo generator - related to power gereration

1 Answers  

WHAT IS OLTC OF TRANSFORMER? WHERE IS ITS USED EITHER ON PRIMARY OR SECONDARY SIDE OF TRANSFORMER?

2 Answers