Answer / gopal manda

100Komh

Answer / rabi

Continue..

However, a resistance of 1000Ohm is considered between hand-
to-feet and also from hand-to hand-or one foot-to other
foot.

Answer / nitu

All the above answers are wrong answers the normal
resistance of human body is about 1500ohms & it varies from
person to person may oftan be less than 1500 ohms.When your
skin is moist, your body resistance could be as low as 300
ohms. Also, breaks in your skin at the point of contact
reduce your skin resistance to nearly zero.

Answer / nitesh

The resistance of human body is (50000 ohm)

Answer / sajin rajan

The resistance of human body varies from person to person.
the recommended value for ELCB tripping is 30 mA, more than
which can create a defibrillation in human heart.if u have
a single phase system (230v ac) then ur body resistance
should more than (230/30)*1000=7666 Ohms = 7.666KOHMS.

Answer / loveness chikwanje

Human body resistancewill be 1000 ohms

Answer / rabi

Value of body resistance including skin range from 500 to
3000Ohm.

Answer / b p

1000 mohm

Answer / kanika sharma

The electrical resistance of the human body depends on the condition of your skin at the time of measurement. If your skin is wet, you could have a resistance of only about 1100 Ohms. With dry skin, the amount is much higher at around 495,000 Ohms.

The electrical resistance of your internal body is much smaller at about 85 Ohms up to 575 Ohms.

Answer / durai

In wet conditions human body resistance will 1000 Ohms, Dry
condition human body resistance will be 1000000 ohms.

Durai.

how can we calculate the reactence of the current transformers?

0 Answers  

Write down the brushes of a de machine.

0 Answers  

In hydro plant,generally we install vertical hydro generators..why dont we recommend horizontal one??

1 Answers   Alstom,

What is the purpose of lighting Transformer used in Industries for Lighting illumination? Its necessary or not?

2 Answers  

We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.

0 Answers  

with the help of drive can we run the 50hz motor on 100hz,what will be its effect.

3 Answers   BPL,

hot water tank,top element 240v across,the bottom 120v across,why?

1 Answers  

if installing the transformer why put the sprit the stone ?

1 Answers  

examples of resistive inductive and capacitive load

1 Answers  

what is the per unit cost of generation of electricity at thermal,hydro,desael,solar,gas power plant

1 Answers  

it is possible to run 130V AC and 230 V AC cables run in same tray

2 Answers  

what is transient stability analysis means?

0 Answers