1 cubic meter contains how many bricks
Answers were Sorted based on User's Feedback
Answer / bishnu kansari
A standard brick size is 0.230m*0.110m*0.075m
after 10mm mortar new brick size is 0.240*0.110*0.085
because mortar used in length wise and height wise not width wise
after mortar volume of 1 brick is 0.240*0.110*0.085=0.00224 cu.m
so,
number of bricks required for 1 cu.m brickwork is
1/0.00224=446.43nos
Is This Answer Correct ? | 0 Yes | 1 No |
Answer / joydeep santra
1 cum bricwork (traditional) - 324 no's. bricks.(practically).
Is This Answer Correct ? | 0 Yes | 1 No |
Answer / irfan khalid
Brick Size in Pakistan = 22cm × 11cm × 7cm = 1694 cubic cm
1 cubic meter = 1000000 cubic cm
Bricks in 1 cubic meter = 1000000/1694 = 590 Bricks
Is This Answer Correct ? | 0 Yes | 1 No |
Answer / sravan
assuming standard size of the red brick as 15*15*15 cm
now
no.of bricks=(1 m^3)/(0.15*0.15*0.15)
=296 bricks
Is This Answer Correct ? | 0 Yes | 3 No |
Which code specifies the specification ofthe construction joints to be provided in the raft slab of a basement which is 6 m deep.what should bethe detail of such a joint?
strength vs shape factor
What is the PH value for domestic water supply
How many steel is require in one cubic meter area?
what is compressive strength of bricks?
Before casting a basement roof slab which is connected with retaining wall surcharge load (i.e. sand or earth filling) outside the retaining wall is prohibited because of––
providing, fixing, removal of pockets of size 100*150*300mm to 500*600*1000mm for foundation. the shuttering material used for making &fixing of pockets shall be removed by the contractor without damaged to pockets. if any damage occurred, the same shall be rectified by the contractor is to handover the pockets to forge shop engineer with proper marking of centre lines, levels etc.
what is Quality Reporting?
what should be the deduction for bend in stirrups while calculating cutting length? Is it 1 dia at each bend?
What is 1/8 on the architect ruler denotes?
WHAT IS THE UDL OF TOWER CRANE?
What are the methods of measurement? Describe it shortly