can we make a loop
between neutral and body
for grounding?
Answers were Sorted based on User's Feedback
Answer / tanmoy
neutral and earthing both are grounding but
individually,both grounding should not be mixed any where
because earthing used for short circuit current from
installed machine to ground for protecting leaving beings or
machine but neutral is used for returning cable/for complete
any circuit.
Is This Answer Correct ? | 2 Yes | 0 No |
Answer / k.prakashchandra
Both Neutral and grounding are earthed.But neutral should
not be used for groundig , as phase and neutral wires may
get interchanged and neutral wire may carry leakage voltage
due to loose joint
Is This Answer Correct ? | 1 Yes | 0 No |
what is cause of static electricity? I experience shock when i touch metal equipment in a room ,furher check shows earth leakage showing 80ma at the DB near to the 400 MCCB?
What is power factor why we should maintain the power factor unless what will happen
r we are using in gas turbine mark (5) frame (6) (made in india Bhel 1997) Ā
why crgo core is used in transformers?
working principle of induction motor is similar to transformer. but what makes it to rotate? then why the transformer doesnt?
a power supply to be constructed from voltage cells is required to provide Max. 20A Current with a terminal voltage of 6v.Several voltage cells are available each of which has terminal voltage of 1.5V & each of which can supply a max current of 5A .the no of cells required will be ??
WHat is the requirement of installing FAST ACTING EARTH SWITCH in GIS and how is that integrated with protection system. How and when does it operate?
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
What are the advantages and disadvantages of the ac motors?
What are the different condition monitoring techniques for a motor?
What is IDMT relay how it works.
3 Answers Electrotherm, Sulzer,
what will happen to the core losses if we perform the open ckt test on high voltage side of a transformer ?