difference between torque mode and speed mode

Question Posted / jivraj

4 Answers
12197 Views
JSW, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

difference between torque mode and speed mode..

Answer / s.ramamoorthy

Torque mode:
The equipment run in low speed at high torque,same time
power also maximum.

Speed mode:
the equipment run in high speed at some less torque,power
also rated.

Is This Answer Correct ?

13 Yes

3 No

difference between torque mode and speed mode..

Answer / s k deo

In Torque mode: Required Torque to be maintained
irrespective of speed.

In Speed mode: Required Speed to be mainted irrespective of
Torque.

Is This Answer Correct ?

5 Yes

0 No

difference between torque mode and speed mode..

Answer / okuku-one

torque mode; every M/Cs requires a high torque to get
started and after awhile it normalcies and the speed mode,
is after like 30secs of start up.

Is This Answer Correct ?

0 Yes

1 No

difference between torque mode and speed mode..

Answer / jivraj

Is This Answer Correct ?

2 Yes

16 No

Post New Answer

More Electrical Engineering Interview Questions

in the Distribution system .which one is Most Economically used by Power Engineer ? a)3 Phase3 wire System or b) 3Phase -4wire System

6 Answers APTransco,

what is the maximum rating(KVA) of transformer can be used in distribution side..(11KV/440v) and why??

1 Answers Jindal,

How to calculate KVA/VA rating of PT or CT from primary & secondary voltage or primary & secondary current?

0 Answers

how to calculate kvar in Akiva

0 Answers

why breather cap filled with oil?

7 Answers

In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.

0 Answers

how percentage impedence effect on the size of the power transformer?

2 Answers Bhel,

how does relay works?

16 Answers

pleasee tell me the risks and hazards of a Cable Jointer job? Thank you.

1 Answers

L.A. (Lightening Arrester) is located at a place from where transmission line enters the transmitting substation. So L.A. (Lightening Arrester) is the first equipments which has to encounter with lightening, high voltage surges and switching surges. It has to absorb energy of lightening, high voltage surges, and switching surges. L.A. (Lightening Arrester) is made up of layers of semiconductors. If these layers can not tolerate energy released by lightening, high voltage surges, and switching surges the L.A. (Lightening Arrester) blasts.

0 Answers

in three phase circuit neutral failure what happend in homes

4 Answers

kva/kvr

2 Answers

For more Electrical Engineering Interview Questions Click Here