Interested to Buy Any Domain ? << Click Here >> for more details...
difference between torque mode and speed mode
- 4 Answers
- 12209 Views
- JSW, I also Faced
- E-Mail Answers
Answer Posted / okuku-one
torque mode; every M/Cs requires a high torque to get
started and after awhile it normalcies and the speed mode,
is after like 30secs of start up.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
What are the various types of rotor used in the alternators?
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
Is it possible to measure the voltage of a battery from a single terminal?
what is the use of current transformer in power transformer secondary side.?its connectyed in WTI
What are the types of control system?
What is meant by sag?
For an induction motor wat is the loading/unloading cycle duration or interms of L/UL ratio/ percentage?
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
what is meant by re-rolling motor? how it differs from standard motor?
Hi, This is Laila. I am selected for syndicate bank interview. Could you please share your views and the questions asked if you have faced the interview My email id is laila_honey09@yahoo.com Please send as fast as u can.Thank You Thanks... Laila.
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
What are the main advantages of generalized error co-efficients?
why dimmerstate always connected in star connection? what will happen if it connected in delta?
