Answer / raju

Relays are 3 types
1. Mechanical relay
2. electromechanical relay
3. numerical relay
RELAY WILL SENCE THE FAULT CURRENT THROUGH CURRENT
TRANSFORMER AND IT WILL GIVE A COMMAND/ SIGNAL TO TRIPPING
COIL WHICH WILL TRIP THE BREAKER.

Answer / rvg

Relays are electro-mechanical switches, and it needs some
power either AC/DC to operate the activation coil.
As soon as the coil gets magnetised, the contact attached
will make/break.

Answer / anand shukla

a relay is a sensing device ,which sense the fault and give
signal to the circuit breaker.
relay are many types which is is used in different
conditions.
1- electromagnetic relay
2- thermal overload relay
3-directional & nondirectiobal relay.
4- distance relay
5-mho relay
6-trip circuit supervision relay
7- master trip relay.
in realy some types of contacts are fitted
like no and nc which is interchange when current exceed a
preset value it means when relay operated.

Answer / simpal

Relay is basically a switchgear which senses the fault
occuring in the system and give signal to circuit brekar 2
remove the healthy part from the faulty part

Answer / xxx

Sorry santhosh you are answer is not correct.

Answer / chowndaryaa sehar

Relay is the device which will sense and isolate the fault
by giving a signal to circuit breaker with help of a
controller chip.

Answer / ramanharikrishnan

Relays are working with sensation of fault while
occuring in system.

Answer / sindhuja

Relay works with with inputs of CURRENT... VOLTAGE..
BASICALLY- CURRENT OPERATED AND VOLTAGE OPERATED.
Relay has the element.
if the element sense the I or V .. which crosses the set
valve .. then it operates.

Answer / nagesh

Relay is switch which can be operated by rated power supply
at the rated current...Relay consists of NO and NC contact
which operates depending on the Coil

Ex ---NO contact will become Close when relay is activated
------NC contact will open when relay is energised

Answer / bhumi

Relay is one kind of electro mechanical device with is
intended to sence the fault(the situation which is opposite
to its normal operation & as well as the function of the
relay for which it has been made)& to give command to the
circuit breaker immediately to isolate the faulty part from
the healthy portion to save the entire system.

Determine the minimum cable size for a 28A single phase final sub circuit originating from the distribution board supplied by three phase submain. The route length of the final sub circuit is 54 m. Assume 1% voltage drop in the consumer's mains. Submain specification: Cable: 50mm2 4 core V75 copper; Route length 42m; Maximum demand 135A per phase

1 Answers  

In UPS what does 600va reffer to?

4 Answers  

difference between local breaker backup relay or backup protection relay ?

1 Answers  

how to calculate no load losses units comsumed by transformer

2 Answers   MRF,

salam, hi, how to calculate british temperature unit (B.T.U)?

1 Answers  

why power not passes in plastic and rubber material

0 Answers   GPG,

advantage of using 110v than 230v

1 Answers   NTPC,

in an open circuit. test there is no load curent.. but secondary. ia open then no urrent have to flow but there a smaller current flows why?

4 Answers   Rubber Park,

What will happen if the rotor of an induction motor is fed from a 3 phase supply and the stator short circuited ?

4 Answers  

What is C curve and D curve of MCB?

3 Answers   GMR,

What are the main parts of central chiller plant? Explain the function of each stage.

0 Answers   HSL, Shankar Electricals,

an ac induction motor gets overheated when operated at a low frequency of 25 hz a instead of 50 hz. reason?

1 Answers