Answer / nagaraju

diesel engine works on principle of compreesion and the
perol engine works on the principle of spark,and if we r
poured petrol in to the diesel engine it is not work,

Answer / prabhat patel

beacuse of higher compression ratio we r unable to attain a
firing point in case of siesel engine, using petrol as a
fuel. and there is no any ignition system so ignition of
fuel is not possible. so diesel engine cant ruv with petorl.

Answer / chanchal sharma

Nothing happens, i think
because In petrol engine , spark plug ignites the Air+Petrol
mixture.
while In diesel engine, there is no spark plug, instead the
Air+diesel mixture ignites due to compression.

So nothing happens since there is no combustion take place.

Answer / guest

high knocking occurs

Answer / nagarjuna

what happen if diesel is poured in petrol engine

Answer / suraj

after putting petrolinto diesel engine it will work but it
milege decrease and after same days it will start knocking
and stop forever .

Answer / divyesh

DUE TO PETROL HAVE LOW DENSITY,SO DIESEL WILL FLOAT OVER
PETROL.ENGINE WILL START BUT DUE TO LOW IGNITION TEMP. OF
PETROL KNOCKING WILL OCCUR........

how can we improve the efficiency of marine ship?

1 Answers  

which type of material is F125?

0 Answers   GTS,

On what basis can sliding contact bearings be classified? Explain?

0 Answers  

Hi! Greetings of the day. Can somebody tell me about as built duct sheet area calculation method. As we know that for this purpose A = (W+H)*2*L. But I have query about multiplication factors for elbows, tappers, offsets etc if there is any. Also refer the papers if available. Please revert. Thanks in advance.

0 Answers  

What is the purpose of thrust bearing?

1 Answers   RRB,

Where can you find thermometers in diesel engines?

0 Answers   RRB,

WHAT IS A TR REQUIRED IF AIR FLOW 6500 CMH COIL INLET TEMP 7 - 12 DEGREE C AIR TEMP INLET - 18 DEGREE C & REQUIRED TEMP IS 12 DEGREE C

0 Answers   TATA,

What is code used in process piping system?

4 Answers  

can a horizontal mount motor be used vertically?

2 Answers  

What is most significant between cp & cpk

1 Answers   Aurangabad Electricals,

Wasco Interview 1-the type of transducer that convert mechanical movement into a voltage 2-pump 2500 psi and 100 MG select it 3-modes of heat transfer 4-the difference bet PSIA and PSIG 5-the function of relief valve and no return valve (check valve ) 6-types of bearing general catogires 7-function of bearing 8-compressor surge 9-pump cavitation 10-define critical speed 11-compression ratio decease volumetric ratio ........... 12-using inter-cooling in multi stage compressors to ....... 13-using cascade system in refrigerator function ? 14-define performance and efficiency .

0 Answers  

in which welding process liquid metal is poured?

18 Answers   ABB, NTPC,