What is core balancing in
Power Transformer. What is the affect of an unbalabce core.
Answer / jakeer
To construct the core with equal dimensioned lamination plates.the effect of unbalance core will causes flux variations due to this out put voltage will be fluctuated
and transformer losses (iron & copper) will be produce.
Is This Answer Correct ? | 3 Yes | 0 No |
why current is leading in capacitor?
What is meant by celling voltage & current in excitor ?
can we step up dc power using transformer?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
what is the tolerance for the magnetic balance test conducted on the distribution transformer?
please can i know about total harmonic distortion and how i can calculate it and if anyone can help me to find any program to help me to calculate THD?? please need it
How can i calculate the Breaking capacity of molded case circuit breaker, is the breaking capacity of CB for Diesel generator shall be less than grid supply's breaker ?
What is the difference between surge and impulse?
what is an alternator & generator
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
If we give the 440 V supply at secondary winding of the transformer then what will affect at primary winding???????
I find that underground strip-armoiured,4core,LT PVC cables in an earthed power distribution sytem are occasionly found in charred condition-with no trace of it except ash. Is this because of no proper earth connection/continuity (giving rising to high armour resistance)in the joint enroute or because of insufficient capability (again due to high armour resistance)of cable-armour to carry fault current or due to neglected /unprotected overloading of the cable or due to high armour currents caused by power thefts where only phase(s) are unauthorisely tapped & at the point of poer consumption earth terminal is established by burring underground a not so good earthing rod (or using an underground water pipe for the purpose)