Answer / anand pandu

THERE WILL BE ONE NUTRAL WHEN SUPPLY COME OUT FROM
SUBSTATION THEN WE USE ONE PHASE AND NUTRAL FOR SINGLE
PHASE .

Answer / shaikh

we can add a neutral line with 3 phase supply (4 wire
system), then supply either single or three phase.

Answer / kj

A neutral will be required.

A single phase and neutral can be used leaving the other 2
phases unused.Or the single phase loads be connected
between each of the separate phases and the common neutral.
The single phase loads can be balanced across the 3 phases
in this way.

Answer / sathi

BKCHONAR

which sub is most horrible in four yr degree

2 Answers  

---

how to claculate the ups load in KVA pls give the if any fourmoul?

4 Answers  

---

what is the design factor that affects the size of a motor ?

3 Answers   Reliance, SGI,

---

Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?

0 Answers  

---

11kv = LT 440v , how many amp.supose 440v side 5000 amp curent drown

2 Answers   Motwane,

---

What is the difference between hot and cold loop testing?

0 Answers  

---

What is the need for a controller?

0 Answers  

---

what is difference between VAT & CST

1 Answers   MIT,

---

In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?

0 Answers   TATA,

---

what is the HT motor current setting (Motor protection relay)aganist FLA If the capacitor is connected in parallal to the motor to increase the P.F from 0.89 to 0.99. the setting is to be reduced. what is the formula for to calculate the current.(FLA - CALCULATED CURRENT!= )

1 Answers  

---

what is the value of current as well as voltage upto which we will not feel shock and why?

3 Answers  

---

electrical knowelge

0 Answers  

---