How would you supply a single house hold load from a 3-phase
supply coming out of a sub-station?
Answer Posted / shaikh
we can add a neutral line with 3 phase supply (4 wire
system), then supply either single or three phase.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
Why squirrel cage motor can only use with low starting loads ?
how does ELR works? explain
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
how to calculate the Neutral transformer impedance?
why d.c produces corrosion
Why should be the frequency 50 hz 60hz only why not others like 45, 95 56 or anything , why should we maintain the frequency constant if so why it is only 50 hz 60hz?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
what are the problems that generally occur in power flows??
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
List out the the types of Mounting Light fixture?
How one may guess the direction from which the distribution line is incoming if there is no pole plate on poles?
please send me privious exam's queation papers of section engineer(electrical).
what the Microsoft .NET framework is?
why the perameters of secondary circuit are more important then that of the primary circuit of induction motor?