Lap length may different for FE 415 and FE 500 Steel, If
different what is the different, In which code is mentioned
Answers were Sorted based on User's Feedback
Answer / shiv
In General Practice, Lap Length is depended upon the
diameter of the bar which we are going to used for lapping.
It is usually taken between 0.4d to 0.6d ...
Is This Answer Correct ? | 41 Yes | 8 No |
Answer / gurusharan
Laping length is different due the tensile strength of both
is not equal.
Is This Answer Correct ? | 15 Yes | 9 No |
Answer / akram
In General Practice, Lap Length is depending upon the grade of concrete & diameter of he bar which we are going to used for lapping.
It is usually taken 36d for M40 , 46d for M35 , 49d for M25 & and normally used as 50d
Is This Answer Correct ? | 2 Yes | 1 No |
In barbending schedule why is o.42*D is taken. Means why o.42 only???
how clculate excavated or backfilling quantity by simpson's rule
In csae of hume pipes NP stands for Non Pressure bur what does it really mean?
what is tension column?
0 Answers Wah Engineering College,
what are the mixing of M10,M15,M20,M25,M30grades?
What is aggregate?
how much dry volume of cement in 1cum in m20 grade
Please Clear My doubt . We Can Design the size of the beam by manually by the Length of the beam...What is the technique adopted
what will be the cement and sand needed for 1sqm plastering ? for ratio 1:6 and 10mm thick
rate analysis,what is PERT, TMT ,UPVC
in pile foundation pile socketing length depend on which factores?
Why shear forces are usually neglected in column design?