Answer / prashant sharma

it is a high-speed transmission mode in a communications or
computer channel. Under certain conditions, the system
sends a burst of data at higher speed for a limited amount
of time. high frequency of dat transfer from the
transmitter.

how can loop single 4-20 ma to two isolation amplifier? i mean i have two isolation amplifier with 4-20 ma input and 1-5 v output.can i done series connection ?

1 Answers  

---

what is the reason while warning lamp is on while the engine is cranking?

0 Answers   Jindal,

---

how to calibrate control valves & power cylinders & ultra sonic level transmitters

0 Answers   ABB,

---

What is sensitivity of K type thermocouple? Is polarity important in thermocouple connections?

3 Answers   Honeywell,

---

What are the different types of thermistors used in industries? How to the operation of typical thermistor?

0 Answers  

---

A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe

0 Answers  

---

what is the usage of QDV & VOLUME BOOSTER.

2 Answers   ADMA OPCO,

---

Why went

9 Answers  

---

What is the difference between a Extension cable and a copnesating cable.Where can we use compensating cable. Is anywhere compensating cable are used for mv transmission to the indicator.

1 Answers  

---

1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?

0 Answers  

---

why we are not using the turbine flow meter in the steam service?

0 Answers   Jaypee,

---

I have a LT of 10000mmwc range. can i use this LT in 1000mmwc range of tank?? if yes than what happened???

3 Answers   Nirma,

---