Answer Posted / prashant sharma
it is a high-speed transmission mode in a communications or
computer channel. Under certain conditions, the system
sends a burst of data at higher speed for a limited amount
of time. high frequency of dat transfer from the
transmitter.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
how to rectify the poor signal strength in utrasonic digtial flow meter ,model:ge digital xce868i
Programmable Logic control.
Why not come out analog output in ABB EL3020 when display show correct value
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
What is the procedure of calibration of Load cell?
which processor is used in dcs.
Explain about the leakage class of the control valves
How hart protocol can be connected with control valves?
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks
There are many type of control cable like pair,core,tried, What are defination each one
How ejector(or)evactor air pump is working in thermal power plant?
