what is the basic working principle of I/P and Positioner in
any control valve.
Answers were Sorted based on User's Feedback
Answer / parag pathak
I/P works on Motion Balance and Positioner works on Force
Balance priciples
Is This Answer Correct ? | 5 Yes | 20 No |
How to calculate the flow rate in Vortex flow meter?What is K factor?Can you give me an example calculation to understand the same as better?
What s the exact height of installed transmitter?
What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?
0 Answers Process Control Technologies,
difference b/w single acting and double acting actuator by using application only?
what is the difference between Ethernet unmanaged and managed Switch?
what is preventive maintenance , explain with difination
1 Answers Bapco Bahrain Petroleum Company,
HELLO FRIENDS plz tell me which are the PROTOCOLS we are using in PLC
a pressure transmitter with a range of 0 to 2500kpag has a specified accuracy of 0.5 % of span.It is to be calibrated using a comparison gauge to have an accuracy of 0.1% of span.The comparison gauge has a range of 0 to 3000kpag What is the accuracy ratio? is this ratio acceptable?
What is the difference between HMI and SCADA and MMI
which one is best profibus or RS485 for communication?
Why using negative voltage in vibration measurement?
what happen if i install my pressure transmitter below the elevation of pipe in natural gas service. Also support your answer