Answer / amarnath

There is no formula for the same but usually in low voltage
its 750mm between power and data cables is maintained and
in High voltage its 1.5m with good protection around the
data cables is a must in both the cases.

When induction motor is started,we see all other electrial appliances connected on the same supply are dimmed out for some moment why?

4 Answers  

---

what is the design voltage for 6.6KV 2000 KVAR HT capacitor?

1 Answers  

---

what happen ehen synchronisation is done at below rated speed

0 Answers  

---

differentiate PLC,DCS,SCADA?

1 Answers   SAS,

---

how to calculate multiplying factor with ct ratio 400/5

1 Answers   KBPL,

---

---

explain single phase series motor

0 Answers  

---

what is the primary current in 415/415 v when secondry of dry type transformer is shorted.?

3 Answers  

---

In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?

0 Answers  

---

What happen if ac supply is fed to rotor of the alternator?

1 Answers  

---

Hot Water System (HWS). Will a 30ma elcb have more nuisance tripping than 100ma elcb

1 Answers   CIMC,

---

What is the Current equation in series RLC circuits.

0 Answers   ABB, Bhel,

---

how to calculate bus-bar sizes? (copper bus-bars)

2 Answers  

---