WHICH KIND OF ADDITIONAL PILE DRIVEN TO INCREASE THE
CAPACITY OF SUPPORTING LOADS ON VERTICAL PILES
Answers were Sorted based on User's Feedback
In Abutment walls (A1 side) why we are adopting fixed bearing (POT-PTFE)?
1)What is Suggested type of cement for concreting at water, for mass concreting and where the chaces of gettin attucked by salt? 2)How many types of camber? 3)why we always preffer short column in case of residential building? 4) Is there any advantages between the use of One way slab & two way slab? 5)What shoul be the % of steel for R. C. C. perpose based on volume & area ?
what is the percentage of binding wire required for 1 mt of steel binding in gerally
how to replace 8mm bar with 10mm bar if the the 8mm bar is not available..???
what is right & short method of measurement of slab&beam
Is the ratio fixed for M-20,M-25,M-30,M-35....grades of concrete??
2 Answers Ahluwalia Contracts, L&T,
Why do you want to work here
what is mix design in mortar mix?
how to calculate cement coefficient for 20mm thick vitrified tiles flooring with cm 1:4 with explaination
why we used bricks in brickbat coba? main roll of bricks ? how it function?
3 Answers Brigade, Waskom Construction,
What are the uses of layer?
during site visit if i find voilation going on,what can i do,how i act?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)