Answer / sandeep challa

High pressure drop
cost of construction is also high

Answer / amol deshpande

In bubble cap distillation coloumn, the cap above the downcomer can be blown out from it's position under the effect of high pressure. High Pressure drop is main problem encountered in valve.

Answer / ajithkumar

in bubble cap distillation problems
1. high pressure drop
2. material cost
3. reflux ratio
4. purity

Question 73 - (a) A dryer reduces the moisture content of 100 kg of a potato product from 80 % to 10 % moisture. Find the mass of the water removed in such drying process. (b) During the drying process, the air is cooled from 80°C to 71°C in passing through the dryer. If the latent heat of vaporization corresponding to a saturation temperature of 71°C is 2331 kJ / kg for water, find the heat energy required to evaporate the water only. (c) Assume potato enters at 24°C, which is also the ambient air temperature, and leaves at the same temperature as the exit air. The specific heat of potato is 3.43 kJ / (kg °C). Find the minimum heat energy required to raise the temperature of the potatoes. (d) 250 kg of steam at 70 kPa gauge is used to heat 49,800 cubic metre of air to 80°C, and the air is cooled to 71°C in passing through the dryer. If the latent heat of steam at 70 kPa gauge is 2283 kJ / kg, find the heat energy in steam. (e) Calculate the efficiency of the dryer based heat input and output, in drying air. Use the formula (Ti - To)/(Ti - Ta) where Ti is the inlet (high) air temperature into the dryer, To is the outlet air temperature from the dryer, and Ta is the ambient air temperature.

1 Answers  

---

What is screen analysis and what are its applications in the chemical industry?

0 Answers  

---

What are the merits of using a falling film evaporator?

0 Answers  

---

ENGINEERING PHYSICS - EXAMPLE 30.5 : (a) Let | A > = (Aa Ab Ac), | B > = (Ba Bb Bc), | C > = (Ca Cb Cc). Find | A > + | C > - | B > in term of Aa, Ab, Ac, Ba, Bb, Bc, Ca, Cb and Cc. (b) Let d | E > = d (Ea Eb Ec) = (d Ea d Eb d Ec). If | E > = (6 7 8), find the value of 10 | E >.

1 Answers  

---

Why is respiration considered as an exothermic reaction? Explain?

0 Answers  

---

Question 76 - Let C% be the fractional crystallinity, Rs = density of sample, Ra = density of amorphous form and Rc = density of crystalline form. In a polymer, these unknowns could be related by the equation C% = (Rc / Rs) (Rs - Ra) / (Rc - Ra). (a) Find the equation of Rc as a function of C%, Rs and Ra. (b) Two samples of a polymer, C and D exist. For sample C, C% = 0.513 when Rs = 2.215 unit. For sample D, C% = 0.742 when Rs = 2.144 unit. Both samples C and D have the same values of Ra and Rc. Find the values of Ra and Rc in 6 decimal places.

1 Answers  

---

Why catalyst is charging in chemical reaction as high pressurized pellet of tablet?

2 Answers  

---

what is designing step of heat exchanger

0 Answers   Reliance,

---

When an expansion is joint needed on the shell side of a shell and tube heat exchanger?

0 Answers  

---

What is Vacuum? If pressure is less than that of atmospheric, can we call it vacuum? If so some places have less atmospheric pressures, can we call people living there are living in vacuum?

5 Answers   ISRO, TCS,

---

Suppose you have hot oil and cold water, what kind fluid you flow In shell side and tube side and why?

5 Answers  

---

THERMODYNAMIC - EXAMPLE 10.3 : According to Raoult's law, the pressure when vapor is completely condensed, P = x(1) P(1) + x(2) P(2) ... + x(n) P(n) when x(1), x(2) ... x(n) are the mole fractions of component 1, 2 ... n and P(1), P(2) ... P(n) are the vapor pressures of component 1, 2 ... n. A vapor at 74 degree Celsius containing 70 mole % water and 30 mole % ethanol is to be completely condensed. At the temperature of 74 degree Celsius vapor pressure is 0.38 atm for water and 0.97 atm for ethanol. What is the minimum pressure the compressor must be operated?

1 Answers  

---