EXPLAIN SOME IMP QUESTIONS AND ANSWERS ON TOPIC
ELECTRONICS,INSTRUMENTATION.........
Answer / n.praveen kumar
SEND ANSWERS TO MY MAIL:nandagari@gmail.com
Is This Answer Correct ? | 2 Yes | 16 No |
why gray colour is choosing to all instrument panel.why not choosing other colour?
Lube oil pressure transmitter local it's showing 9.8 kg/cm2 but dcs side it's showing 9.26 like that what is the reason?
principle of automatic votage regulator
what is difference between pressure,flow and level control valve.
what is the tempareture conpensation?what is the use of this?
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
how to replace the smart transmitter software
in a electronic controller why we are using 250 ohm resistance in input signal?is i/p is necessary in control valve when we are using electronic controller give details?
Waht is surge in compressors and how to control it?
why bevelling is done in an orifice ?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
What is the diffrence between digital signal processing and discrete signal processing?