Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) a 3 phase motor was running with delta connected, suddenly one phase winding got burnt off, what will be the effect ?
8 17629
What are the disadvantages of thermal power plant?
Explain what is a good way to get started in doing a plant-wide steam consumption analysis?
What Is the Thumb rule to calculate depth and dia of pile required to carry specified load on differeent soil
Witch do depand of Power factor and theory of power factor?
Explain about boutique and its management.
why to use freewheeling diode ( diode in revers bias mode) across dc coil
69,70 or 71 in box-1 ; 18,19, or 20 in box-2 ; 60,61, or 62 in box-3 get -3 , -4 , or -5 in box-2 in 3 steps.Use all operations i.e. ( +,-,*,/ ).
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
how convert sqft into cubic meter and cubic meter into sqft
I have a 2000 Chevy Blazer and when turning on the A/C the accuator opens and closes the panel doors on its own without me touching any controls..i bought a new climate control (350 dollars) and that didnt fix it..can anyone help??
should cutouts made in main header of metal ducting be deducted from duct measurement.
If an electrical component has a positive temperature coefficient, how come such components have high power losses due to heat if current decreases when resistance increases? assuming power given by I^2*R whereby the Resistance is infinite.
What are the major effects of alloying elements?
Define unit atmospheric pressure? Difference between gauge pressure, absolute pressure?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?