Answer / suraj ojha

By using PLC according programed application.

Answer / sarvesh trivedi

Simply connect the two operations in parallel togather and
then connect it with the same switch.

Answer / karan thakur

we can use PLC/SLC as well as Electrical circuit( use of
cotactors, relays and timers etc). PLC is the best option(
we can connect to PC,MMI for better control and monitoring

Answer / sudhir patil

By using PLC ,Use positive edge (rising ) of push
button ,it is possible to make two operation in one push
button.

Answer / raghavan shaji

It is simple by using contactors and auxilary relays to do
the operation. BMS and PLC are the latest versions but
comparitily expensive.

What causes little rust pockets to pop through or off concrete cylinder blocks (home)?

0 Answers  

WHICH TYPE OF DOCUMENTS REQUIRED FOR Q.A.& Q.C

2 Answers  

ANY ONE USED/INTERFACED CITECT VERSION 6.0/1 OR 7.0/1 TO SIEMENS S7-300 OR S7-400 CONTROLLER IF PLEASE TELL ME THE COMMUNICATION STRUCTURE AND ADDRESS CONSIDERATION FOR DI,DO,AI,AO please mail the details lok_pallapolu@yahoo.com Ph:09247513753 hyderabad

0 Answers  

What is producser for Anti collosion protection for DUMER 220Ton in Minse

0 Answers  

i have one air blow heater , coiled heater is in side hollow ceramic tube and passing the air and other end hot air is going out, to control the hot air where i should fix up a THERMOCOUPLE on the heater or on the out let of hot air terminal which is the best way

0 Answers  

What is difference between npn & pnp sensors?

0 Answers  

what is manufacturing audit & resource analysis for developing automated manufacturing techniques & storage system?

1 Answers  

why we use log files in QTP?

0 Answers  

what is impeller clearance?

0 Answers  

what is the electronic presipitator ?

2 Answers  

how to controlTemperature

3 Answers  

any body tell me why 4-20 ma use as a current any reason for this amount why not 3-25 ma?

1 Answers