why we have to do tan delta test of the transformer oil???

Categories >> Engineering >> Electrical Engineering
Suggest New Category

Question Posted / soumik

5 Answers
18539 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

why we have to do tan delta test of the transformer oil???..

Answer / chinni

Tan delta test is test for measuring the insulating
capacity of transformer oil.The value of Tan delta deals
with the leakege current through Insulating oil.

Is This Answer Correct ?

23 Yes

4 No

why we have to do tan delta test of the transformer oil???..

Answer / vels

to determaine the insulation condition if the tan delta
value is higher than 0.7 for a transformer,then oil has to
be tested in all aspects .from the oil results we can under
stand where the insultion is weaks

Is This Answer Correct ?

12 Yes

3 No

why we have to do tan delta test of the transformer oil???..

Answer / sunil guru

tan DELTA test is used to determine the insulation strength of oil
to determine the break down strength,flash point,its fire point,and also to identify the moisture content of the oil

their is certain fix value for all above said......
if the oil colour changes then it may be said that it may not be suitable for large time......

Is This Answer Correct ?

10 Yes

4 No

why we have to do tan delta test of the transformer oil???..

Answer / tapan desai

Know about insulation
degradation of transformer
and power cable.

Is This Answer Correct ?

4 Yes

2 No

why we have to do tan delta test of the transformer oil???..

Answer / pati

Ionic traces can effect the Tan delta of insulating oil
like transformer oil.The amount of charge particle directly
proportional to the electrical properties, hence tan-delta
test essencial for Transformer oil.

Is This Answer Correct ?

3 Yes

3 No

Post New Answer

More Electrical Engineering Interview Questions

-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.

0 Answers

how do we calculate length of starting time and repeated starting of a direct online starter?

0 Answers

a bulb of 100W and anather bulb of 200W , rated supply voltage 230v.when supply voltage is reduced to 100v,which bulb will give more light? and why with calculation?

12 Answers

plz tell me about detailof induction motor Slip

2 Answers

what is diversity factor ? plzzzzzz describe me

1 Answers

what happen if field of dc shunt motor opens? what is function of putting res. in parallel to one phase of 3 phase IM? the power supplied by 5A source in circuit is given by------Watt.

0 Answers

please, Send me last technical test question paper in my email id..

0 Answers

Can I use distributon class/transmission class Lightning arresots for protecting the building? If not why please explain?

0 Answers

If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?

0 Answers

Two 11 kv lines are feeding to common bus in a substation,I have one set of CT & PT(3ct,2pt), How can I measure both lines power using single set.

6 Answers L&T,

how to calculate AH of a battery?

8 Answers Exide,

why all selected supply voltage are multiple of 11

1 Answers Gamesa, Suzlon,

For more Electrical Engineering Interview Questions Click Here