How will calculate the current rating (withstanding
capacity)of alumunium and copper cables?
Answer / guest
minus all the positive ito negativthe vale of the man and
women are equal to th eresult
| Is This Answer Correct ? | 0 Yes | 9 No |
What is the dependency of stiffness on load angle??
How do u analyse protection fault when vcb tripping on load
How to improve the power factor from 0.8 to 0.98? Also tell me cost vs benefit analysis.
physical identification of HT & LT panel
Why distribution transformer secondary voltage is 0.433kV instead of 0.415kV.all other switchgear rating are 415 volt??
how much current capacity 250 amp. mccb please tell me about whats are the reasons to trip 2 or 3 times in a night. and what are the steps to short out this problem
why is a avtomatic voltage regulator used for?
If ac 230volts inputsupply to full wave rectifire what is D C output voltage.
a transformer runs by electro-induction principle like all motors.then why dosen't it rotate just like any other motor
operation of diesel generator
Petroleum jelly is applied to the terminals of the lead acid battery is to prevent?
why use celling fan wing is two or three ?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)