Interested to Buy Any Domain ? << Click Here >> for more details...
When you mistakenly type the wrong command
at the Router# prompt the router does a
DNS lookup which takes about 20 seconds.
Which command can you enter to prevent the
router doing this in future?
- 2 Answers
- 7028 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / jitendera sinha
answer might be
router(config)#no ip domain-lookup
| Is This Answer Correct ? | 7 Yes | 1 No |
Explain isakmp ?
What must be true for two routers running IGRP to communicate their routes? A.) Same autonomous system number B.) Connected using Ethernet only C.) Use composite metric D.) Configured for PPP
What are some standards supported by the Presentation layer?
You want to clear the outputs on your serial interface showing errors on the interface. Which command do you type?
Value in which type of access list?
what is the major difference between EIGRP & IGRP?
what is frame relay?
Why do you use ‘service password encryption’?
Mention what BOOTP is?
Brielfly explain the conversion steps in data encapsulation
What are segments?
What would be the first command from global configuration mode to enable RIP on your router for interface E0, with an address of 181.86.4.4 and mask of 255.255.255.0 ? A.) router rip B.) network 181.89.4.0 255.255.255.0 C.) router rip int e0 D.) router rip 181.86.0.0 E.) router rip 181.86.4.0 F.) network 181.86.0.0
CCNA 
