Answer / himanshu

show ip ospf interface

What are segments?

0 Answers  

---

What do you use the Aux port for? A.) Console B.) Terminal editing C.) Modem D.) Backup logging

1 Answers  

---

Which layer is responsible for identifying and establishing the availability of the intended communication partner? A.) Application B.) Presentation C.) Transport D.) Session E.) Network

1 Answers  

---

A network is vow congested currently all the devices are connected through a hub. Which would best decrease congestion on this network? A. add a second hub B. replace the hub with a router C. replace the hub with a switch D. replace the hub with a repeater

1 Answers  

---

from last ten days i watched that no any new questions are placed in ccna catogarey.so plz place the questions it is very use full to beginers like us

2 Answers   HCL,

---

Identify the command to display the IP host table? A.) show ip hostnames B.) show ip names C.) show hosts D.) show ip hosts

1 Answers  

---

What is the protocol number for UDP? A.) 6 B.) 17 C.) 25 D.) 21

1 Answers  

---

Identify the command that displays traffic statistics on serial0/1? A.) display interface serial0/1 B.) show interface serial0/1 C.) show seria0/1 stats D.) show interface serial0/1 stats

1 Answers  

---

what is difference between subnet-mask and wildcard mask?

6 Answers   IBM,

---

The following is partial output from a routing table ; '192.168.10.0 [100/1300] via 10.1.0.1, 00:00:23, Ethernet1' Which routing protocol is being used? (assuming defaults have not been changed) A.) OSPF B.) RIP C.) BGP D.) IGRP

1 Answers  

---

while trouble shooting a network conectivty prob a technician observes that steady link light on the both work stations nic and the switch port which the workstation is conected.however when the ping comand is issuede from the work station the out message is request time out at which layer of osi model does the prob most likly exist 1 sessiom layer protocol layer datalink kayer acess layer network layer application layer i have ansered n/w layer but i am niot sure i have also posted privous question jitendera kumar sinha

3 Answers  

---

Identify the command to copy a configuration file from a TFTP server to a routers active configuration? A.) Router# copy running-config tftp B.) Router# copy tftp running-config C.) Router# copy tftp 172.16.0.1 running-config D.) Router(config)# copy tftp running-config

1 Answers  

---