Which protocol resolves an IP address to a MAC address? A.) DHCP B.) RARP C.) ARP D.) NBP E.) DNS

4 Answers  

---

What are the things that can be accessed in a CISCO router’s identifying information?

0 Answers  

---

Brielfly explain the conversion steps in data encapsulation

0 Answers  

---

what is difference between packet switching and circuit swtching

0 Answers   ASD Lab,

---

thnx Jitender singh...as u told to install a stp in switches and problem vil b get solved...i wanna kno how to install stp in switches?? plz tel me detailled steps... thanx for ur answer.

1 Answers  

---

Name a major component of the Point-to-Point Protocol (PPP) to negotiate and set up control options on the WAN data link. A.) RFC 1661 B.) High Level Datalink Protocol (HDLC) C.) Challenge Handshake Authentication Protocol (CHAP) D.) SS7 E.) Link Control Protocol (LCP)

2 Answers  

---

When using TCP, after a session is open, the applications can adjust the amount of segments they receive before sending an acknowledgment. This behaviour is known as ______________. FCS Windowing MTU adjustment Flexible Send Path

1 Answers  

---

Which global configuration command will tell the router to load the IOS file 'IOS_filename' from FLASH memory at the next boot? A.) boot system flash B.) boot system flash IOS_filename C.) boot system IOS_filename flash D.) boot system tftp IOS_filename tftp_address E.) config-register 0x0102 IOS_ filename

2 Answers   HSBC,

---

I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

5 Answers  

---

When using access lists, it is important where those access lists are placed. Which statement best describes access list placement? A. Put standard access lists as near the destination as possible. Put extended access lists as close to the source as possible. B. Put extended access lists as near the destination as possible. Put standard access lists as close to the source as possible. C. It isn't import where access lists are placed since the router will read and cache the whole list. D. Put access lists as close to corporate headquarters as possible.

1 Answers  

---

Identify the command to configure the router to boot from an alternate IOS located in flash? A.) boot system flash IOS.exe B.) boot system tftp IOS.exe 172.16.5.1 C.) boot system alternate IOS.exe D.) boot system rom IOS.exe

1 Answers  

---

Which updates called incremental updates?

0 Answers  

---