Interested to Buy Any Domain ? << Click Here >> for more details...
What type of switching creates variable latency through the
switch?
A.) Cut-Through
B.) Inverted
C.) Layer 4
D.) Multiplexed
E.) Store and Forward
- 1 Answers
- 5696 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: E
DEFINITION: Latency = Delay.
Because a store and forward switch reads the whole frame
before forwarding,
a larger frame takes longer than a shorter frame.
| Is This Answer Correct ? | 8 Yes | 0 No |
How many potions of ip?
If a router uses dynamic routing, how does it learn the route to remote networks? The router uses a DHCP request to obtain remote network numbers. The router uses a routing protocol to exchange routing info. with other routers. The router uses DNS request packets to obtain remote network numbers. The Network Administrator manually configures the remote networks.
Given the following IP address from the Class C address range 192.168.21.12. Your network plan needs addresses for 28 small prkps Each office uses its own shored. The network design specifies that you confound for five bits of subnetting. When you confound for this in Cisco IOS software which shored mask should you use? A. 255.255.0.28 B. 255.255.255.0 C. 255.255.255.28 D. 255.255.255.248 E. 255.255.255.252
1900 Value in which type of access list?
Identify the 2 commands that will display the status and information about interface E0 only? A.) show interface ethernet E0 B.) show interface E0 C.) show E0 D.) show int E0 E.) show interface
What is ISR or NonISR router? Difference between ISR or NonISR router?
On Cisco catalyst 5000 how would you set the second port on the controller in the first slot to full duplex? A.) Set port duplex 1/1 full B.) Set port duplex 1/2 full C.) Set port duplex 0/1 full D.) Set port duplex 0/2 full
Identify the OSI layer associated with bits? A.) Physical B.) Network C.) Binary D.) Data link
Which peer authentication method and which ipsec mode is used to connect to the branch locations?
LMI operates between the Frame Switch and what other device? A.) CPE device B.) Another Frame Switch C.) X.25 switch D.) Novell File Server
Identify the command that saves the configuration stored in RAM to NVRAM? A.) copy running-config startup-config B.) copy tftp running-config C.) copy startup running D.) copy active to backup
In which three situations is a hold down timer reset? (Choose three) A. when the hold down timer expires B. when infinity is finally defined as some maximum number C. when the router exchanges update summaries at area borders D. when the router detects faulty LSPs propagating through the internetwork E. when another update is received indicating a new route with a better metric F. when another update is received indicaing the original route to the network has been restored G. when the router receives a processing task proportional to the number of links in the internetwork
CCNA 
