Answer / ro

BANDWIDTH-- >> in general is the total range of frequencies that a system can handle..
BW= Fmax-Fmin

now.. a system is called open loop when there is no feedback.. when feedback(-ve) is introduced(negative feed used as +ve feed will make the system unstable usually), the gain will reduce .. along with that, it lets the system handle more range of frequencies.. thus bandwith increases.. the principle of GAIN*BANDWIDTH is always kept constant.. thus when gain is reduced, BW increases..

thus closed loop system BW increases compared to open loop..

--RO--

What are the key inputs and factors considered to plan the number of SGSN/GGSN if you have to set up a Greenfield network?

0 Answers   Ooredoo,

---

What is the difference between <stdio.h> and "stdio.h"?

2 Answers  

---

In wave guides tem wave propagation is not exit, give the physical interpretation?

0 Answers  

---

In micro controller individual pin output current is 1.6ma .Normally to blink a led we need minium 10-12 ma. But if we connect led to the micro controller pins without additional device it blinks. How it is possible

0 Answers  

---

i have a problem in programming using string program is- rajasthan rajasthan rajastha ajasthan rajasth jasthan rajast asthan rajas sthan raja than raj han ra an r n plz reply soon as posible as

0 Answers  

---

What is an idea current source?

0 Answers  

---

why do we need time domain & frequency domain.Differentiate between them.

1 Answers  

---

What are the differences between voltage and current controlled devices?

0 Answers  

---

Explain what is a state table?

0 Answers  

---

Why can’t we use comparator to convert sin wave into square wave?

0 Answers  

---

why rxlevel is negative valued ???

3 Answers   Ericsson,

---

why six transistors are used to store single bit in sram

1 Answers  

---