Answer / msedcl

In energy meter there r 2 CT's are used.One for recording
current through incoming phase & other through outgoing
phase .When the load is ON on outgoing side the current
flowing through both CT's is compared by electronic
circuit.An wattmeter is calibrated as per standards which
measures wattage proportional to current.

Answer / prashant

in energy meter there is 1 ct for measuring the outgoing
current and other is pt for pressuresed the disk to
rotatiing movement.

Answer / manish

yes , for single phase energy contains the one ct for that
refeance they give out result of current and one pt is
contacted accros to supply so it give out result of volts
and product of curent and volt is watt.

Answer / nageshwaran.n

In Energy Meter 2 CT's are used. One for recording
current through incoming phase & other through outgoing
phase . When the load is ON on outgoing side the current
flowing through both CT's is compared by electronic
circuit. An wattmeter is calibrated as per standards which
measures wattage proportional to current.

What happen if in three phase 440 v , when you check voltage by testor it glows except one phase and in the same time when you check by multimeter it shows 440 v in any two phase.what will be the reason...

1 Answers   Greatship,

---

at what condition restricted earth fault relay will act?

1 Answers   Equate,

---

why two contacts(in series) are using in closing circuit

3 Answers  

---

what is meant by motor startup supervision & motor load jam protection ?

1 Answers   ABB,

---

WHAT IS REACTIVE POWER?

2 Answers  

---

explain the existence of reactive power in electrical engg?when it generates?

1 Answers  

---

if the back emf eqution for dc motor EB=(QPNZ/60A) THEN what is the value of A for PMDC MOTOR OR how can dicide the value of "A"

2 Answers   BSL,

---

What happen if we give resistance to the armatuure of a dc motor?a

1 Answers  

---

what is the transiant condition in alternator? and how it can be prevanted?

1 Answers  

---

how to calculate maximum current

1 Answers   Almeer Technical Services,

---

it is used to measure the potial difference between two point?

2 Answers  

---

What is the calculation for 1000Amps Air circuit breaker relay settings.

1 Answers  

---